previous page



UPCONVERTER 10 GHz provides a transfer (controlled by software) of a spectrum bandwidth of up to 150 MHz, which is received at a signal input, to any point of spectrum bandwidth from 10 MHz to 10 GHz. A spectrum transfer is based on superheterodyne principle with three stages of the down-conversion. Due to this feature, a high level of carrier frequency suppression (up to -55 dBc) and of mirror channel suppression (up to -70 dBc) is achieved in the entire operating frequency range. Also UPCONVERTER 10 GHz has a unique feature to set the value of an output intermediate frequency in the range from 75 MHz to 400 MHz. This feature isnt presented in other devices of similar type. In addition, the device can transmit an input signal frequency from 10 to 400 MHz to an output without conversion. Due to presence of this feature a wide range of Russian and foreign made generators combined with UPCONVERTER 10GHz can be used as generators with increased output frequency range. Holding Informtest offers to customers MGKS and MGVCH generators designed and manufactured by Informtest, as well as the first Russian transceiver module MT-1. All these instruments are fully compatible with the input characteristics of the UPCONVERTER 10 GHz. The UPCONVERTER 10 GHz along with generators manufactured by holding Informtest, controlled by common software shell, presents a synthetic instrument - a turnkey solution for testing of RF devices and radio channels.

Design of the UPCONVERTER 10 GHz assumes it to be used in enclosed mobile complexes used for field tests of communication equipment. For this purpose the instrument utilizes advanced solutions for an output signal phase noise reduction under conditions of increased vibrations and high temperature. The device has a temperature stabilized reference oscillator with ability to output a reference frequency signal. The instrument can also be used with external reference signal generator.

The control software of the UPCONVERTER 10 GHz is made in the standard VXI Plug & Play and independent of the version of the module. The software allows for automated calibration and verification of devices main characteristics.


Output frequency range (RF) 10 MHz to 10 GHz
Output frequency setting resolution:
- INT mode:
- FRAC mode:

50 MHz (50 to 10 000 MHz)
1 MHz (50 to 10 000 MHz)
Input frequency for external reference 100 MHz
Input frequency range (IF) 10400 MHz
Input signal frequency setting resolution
- Direct transition mode
- Conversion mode

25 MHz (75 to 400 MHz)
Input and output frequency tolerance using internal reference, not less than 10-7
IF bandwidth:
- -1 dB
- -3 dB

125 MHz
150 MHz
Maximum input/output power 0 dBm
Level error in full frequency range 1 dB
Input VSWR in 50 Ω system in full frequency range <2
Output level adjustment range 30 dB
Step attenuator range 1 dB
Spectral purity
Non-harmonic distortions -55 dBc
Image suppression -70 dBc
SSB phase noise carrier -75 dBc @100 Hz
VXIbus: +12 VDC
Ext. source: +12+28 VDC
Remote control: - UPCONVERTER 10 GHz VXI

Ethernet(TCP/IP) USB
General data
Power consumption 27 W (means)
Dimensions LXI (WxHxL) 250 mm × 50 mm × 270 mm
Weight (LXI) 3.2 kg

previous page



In 2007 Holding "Informtest" got the status of VXIbus Consortium Sponsor Member.
LXI Consortium

Holding Informtest is an Informational Member of the LXI Consortium since 2007.
AXIe Consortium

In 2012 Informtest Holding became the first and only Russian control equipment producer, admitted to the international AXIe Consortium.

Our partners

M+P International Ametek   Test Evolution
- - PHPShop. 2003-2017.